Phison Ps225107ps2307 Hot Here

If you have searched for the term , you are likely experiencing the same frustration as thousands of other USB flash drive users. You plug in your drive—often a Kingston DataTraveler, Corsair Voyager, or Patriot Memory stick—and within minutes, the casing is too hot to touch. Data transfer speeds start high (100+ MB/s) but suddenly plummet to single digits (2–5 MB/s), and the drive may even disconnect from Windows with a “USB Device not recognized” error.

| Symptom | What is happening | | :--- | :--- | | after 2 minutes of copying a large video file. | Controller junction temp exceeds 80°C. | | Speed suddenly drops 90% (e.g., 100 MB/s → 10 MB/s). | Firmware thermal throttling activates. | | Windows "Code 43" or "USB Reset Failed" | Controller thermal shutdown causes a voltage sag, disconnecting the USB bus. | | Copy pauses for 10-20 seconds before resuming slowly. | NAND controller enters error recovery mode due to bit errors caused by heat. | | Drive disappears and reappears in File Explorer. | Thermal protection circuit tripped. | phison ps225107ps2307 hot

The (often labeled on the chip as "PS2307") is a USB 3.0 to NAND flash controller. It is a single-chip solution designed for high-speed external storage. Launched in the mid-2010s, it became infamous for its aggressive performance tuning. If you have searched for the term ,

A: No. Condensation will short-circuit the PCB. Let it air cool for 20 minutes. | Symptom | What is happening | |

A: No. 70°C is the danger zone . Normal should be 35°C–50°C.

Early revisions of the PS2307 firmware had no temperature throttle. The controller would run at full speed until the NAND flash's solder joints began to reflow (soften). Later firmware added throttling, but it is reactive, not preventative. By the time the throttle kicks in, the drive is already dangerously hot.

By: Tech Recovery Labs